Attach the handlebar weight.

Align the tab on the handlebar weight with the recess in the handlebar.

Insert the weight into the handlebar and attach it with a 6 x 65 mm oval head screw.

Torque the screw.

Torque: 10 N·m (1.0 kgf·m, 7 Ibf-ft)

Install the front brake master cylinder.

Place the master cylinder assembly on the handlebar. Align the edge of the assembly with the punch mark on the handlebar.

Set the master cylinder holder, with its UP mark facing up, on the assembly.

Attach it using two 6 x 22 mm flange bolts. Torque the two bolts, starting with the

top one.

Torque: 12 N·m (1.2 kgf·m, 9 Ibf-ft) Connect the brake light wires to the master cylinder terminals.

Install the turn signal switch.

Position the switch assembly on the handlebar by inserting its pin into the hole in the handlebar and aligning the end cap with the groove in the switch assembly.

Attach the switch assembly using a 5 x 45 mm screw/washer in the front hole and a

5 x 35 mm screw/washer in the rear hole. Torque the screw/washers, starting with the front one.

Torque: 4 N·m (0.4 kgf·m, 3 Ibf-ft)

HOLE

END CAP

5x35 mm SCREW/WASHER

SCREW/WASHER